WIFI IOT NodeMcu Lua Internet of Things ESP8266  Programming Learning Starter Kit

WIFI IOT NodeMcu Lua  Internet of Things ESP8266  Programming Learning Starter Kit

Product Description

For more sample codes and DIY project tutorials, please go to the website

If you need software support or other firmware support, please contact customer service

13 Sample Projects for Beginners:
P1: Use NodeMCU to send voltage changing value to MQTT client
P2: Remotely control LED with NodeMCU through MQTT IOT broker
P3: Use NodeMCU to publish light sensor value to internet through MQTT
P4: Use NodeMCU to send push button signal to remote MQTT client
P5: Use NodeMCU to send temperature/humidity data to MQTT IOT broker
P6: Use NodeMCU to send tilt sensor value to remote MQTT client
P7: Use NodeMCU to display MQTT IOT message on I2C1602 LCD
P8: Use NodeMCU to show MQTT IOT message in 4-digit LED
P9: Use NodeMCU to control Step motor through MQTT IOT protocol
P10: Use NodeMCU to control servo motor through MQTT IOT protocol
P11: Remotely control Buzzer with NodeMCU through MQTT IOT broker
P12: Use NodeMCU and Infrared Receiver to send signal to MQTT client
P13: How to read resistor color code

Package list:
1x ESP8266 WIFI NODEMCU Board
1x Micro USB cable
1x I2C LCD Display
1x Servo Motor
1x DHT11 Temp & Humi Sensor Module
1x Tlit Sensor(SW-520D)
1x 4 LED module
1x Stepper Motor + Bridge
3x Potentiometer (10kilohm adjustable resistor)
1x Buzzer
3x GL5516 Photoresistor (Light Sensor)
1x Infrared Receiver (VS1838B)
1x Infrared Remote Controller
24x LED (6x White, 6x Red, 6x Yellow, 6x Green)
5x Push Buttons
5x Push Button Hats
1x Breadboard
1x 4AA Battery Holder
65x Resistors(20x 200ohm, 20x 10Kohm, 20x 1Kohm, 5x1Mohm)
40 Pin Jumper Wires (15cm, M to M)
16 Pin Jumper Wires (20cm, F to F)
1x Plastic Box